Christmas Ornaments

I have been meaning to post this for quite some time now, but was unable to due to various computer issues.  So here's my latest finished craft!

I love Bath and Body Works.  It's like an addiction for me.  A few years ago around Christmas, I was changing the bulbs in my wallflowers, and go to thinking that they are a bit of a waste.  Everywhere you look now, people are talking about recycling and reusing products.  I came up with this fabulous idea, and it has now taken me roughly 2 1/2 years to complete.

Christmas Light Bulbs!!!

Supplies:

Wallflower bulbs and lids (You choose how many.  I think 1 or 2 dozen is great).

Silver Ribbon (1 spool is enough for about 15 bulbs).

Tinsel

Spray Paint Primer

Silver or Gold Spray Paint

Pencil or Pen

Power Drill and bits for plastic

Pliers

Newspaper

Masking Tape

First you need to make sure your bulbs are completely dried up--The oil strips the tinsel of its color.

With a pair of pliers, grab the wick like so, hold the bulb with your other hand, and pull out the wick.

Hopefully the wick and plastic ring around it will come out together.  If not, just pull out the ring with your pliers. 

Get your tinsel, and cut 2-3 inches (about the length of the bulb).

Carefully stuff the bulb with your tinsel.  I use a thin pen or pencil to help guide it in.

Voila!

I forgot to get a picture of this next step.  Drill a hole into the top of the lids, using a bit a little smaller than the tip of the lid.

Next, take your lids outside, along with plenty of newspaper, masking tape, spray primer, and spray paint.  Lay out your newspaper and tape the edges down to prevent the corners from flying up and knocking over your lids as they dry.  Coat your lids with primer, which will help the paint stick and coat more evenly.  Let it dry completely, at least 3 hours.  Then spray your lids with your paint.  I used Krylon Metallic Silver Foil.  Be sure to set this up and spray in a clear area.  The paint particles float around for a while, and you definitely don't want them getting near your car.  Let the paint dry completely, and apply more coats of paint as needed.

Close up:

When they are dry, it's time to thread them with your ribbon.  I liked this ribbon because it looked like the wiring for Christmas lights. Thread your needle and pull the ribbon up from inside the lid, pulling it out the top.

Then thread the needle back down the hole...

And make sure you hold your pen or pencil through the loop to make sure it doesn't fall through.

Tie a knot in your ribbon, making sure it's big enough to not go through your hole.

 Screw on your lid, and you are done! 

Don't they look amazing?!  I think they'll look perfect on the tree this Christmas.